Take the pain out of loading and unloading heavy barbells for deads and other lifts that start from the ground. Just prop the jack under the bar, pull the handle back to elevate, and slide on more weight just like you would if the bar was racked.
The Deadlift Bar Jack is assembled at Rogue Manufacturing in Columbus, Ohio, and is strong enough to keep even a fully loaded bar off the ground and steady for as long as needed. UHMW plastic is also now included to protect the bar’s knurling and finish through repeated uses.
- Made in the USA
- 2×2” 11-Gauge Steel
- 1/4” thick formed steel cup with protective UHMW plastic
- Can lift any standard barbell from floor level, allowing easy loading/unloading of weight
- Length: 42″
- Width: 19″
- Handle Length: 34”
Leave a Reply